Tellabs Products
From entertainment and telecom in the home to patient information in healthcare, from financial data to homeland security; fast and secure access has never been in more demand. Tellabs' sole focus is to deliver secure, scalable, sustainable access to optimize network performance.

Tellabs Network Solutions Suite

Tellabs Optical LAN delivers a network that is faster, more efficient, sustainable, cost effective, scalable and adaptable to future requirements than traditional copper-based infrastructure. Optical LANs eliminate the distance constraints, power requirements and heat dispersion issues of copper. They deliver increased network security, performance and operational efficiency. There is no doubt: Optical LAN is the future of enterprise access networks.
Tellabs provides an end-to-end cost-effective broadband access solution that passes more than 5 million homes in North America. Our multiservice access platforms enable you to get the most from your existing infrastructure. You'll save costs by reducing power consumption while gaining revenue opportunities by delivering services faster. Tellabs T1000 - the industry’s only Broadband Digital Loop Carrier platform that converges legacy copper and modern fiber connectivity.
(10 Matches)

Small 1048 Channel Bank Assembly (CBA)

  • Supports traditional narrowband and modern broadband services
  • Equip with TDM, SONET or Ethernet plug-in cards
  • Capable of 100% xDSL fill rate
  • -48v power rail to all slots
  • Rapid deployment from any existing cabinet
  • Full NMS control integrates existing access networks
  • Alarm contact closure wire-wrap posts
  • Wire-wrap backplane only for complete flexibility on a slot per slot basis
  • On-board craft port with A/B switch for modem interface
  • Variable speed fan tray assembly

10 Gigabit Ethernet 226 (GbE226) – Limited Availability

  • Four 1G Ethernet ports small form-factor pluggable (SFP)
  • Six-Port Ethernet switch/hub with flexible uplink and tributary functionality
  • Port filtering
  • Flow control
  • Configurable Layer-2 learning
  • Spanning Tree forwarding
  • 1526 Byte Maximum Transmission Unit (MTU)
  • Two 1G/10G Ethernet ports enhanced small form-factor pluggable (SFP+)
  • Standard SNMP based Ethernet statistics
  • Hardware support for future Synchronous Ethernet (SyncE) and IEEE 1588 Precision Time Protocol (PTP) timing
  • 6-Port Managed Layer 2-switch with VLAN awareness
  • Flexible configuration of 10G uplinks and 1G aggregation ports
  • SNMP based Ethernet statistics
  • QoS via IEEE 802.1P priority bits
  • IPv4 and IPv6 transparency

ADSL2+ 6+0B Plug-in Card with Bonding

  • Dual memory for minimal service-affecting upgrades
  • Compatible with both CPU-2 and CPU-3
  • High performance provides higher bit rate and broader reach
  • Low power/heat dissipation for increased capacity
  • Supports ADSL2 Reach Extended (RE) option for longer reach
  • Provides ADSL2 power saving states
  • Up to 48 VCCs per card
  • Six integrated ports of ADSL2+ (with bonding capability) and POTS
  • Up to 20 cards per Tellabs 1000 MSAP shelf
  • Unspecified Bit Rate (UBR), Constant Bit Rate (CBR) and Variable Bit Rate Real Time (VBRrt)
  • Receives and responds to F5 Operations and Maintenance (OAM) loopback cells

E&M Special Services (E&M) Plug-in Card

  • End-to-end compatibility with existing cards in the field
  • Two circuits per card, each able to support different provisioning
  • Software-provisionable E&M and PLR modes (2-wire or 4-wire)
  • Provides one or two E&M circuits per card, depending on modes: E&M Type I, II, III, IV, V and PLR I and II
  • Software-provisionable Tandem and DX modes (4-wire only)
  • Provisionable transmit and receive gain
  • Provisionable bias (switched or fixed — DX mode only)
  • Post-equalization
  • 600 ohms and 1200 ohms fixed impedances
  • Normal and reverse DX signaling

52EU 1000-Line Remote Outdoor Cabinet

  • In controlled environments, if the composite clock signal degrades, ETI provides Stratum 3E holdover using historical timing data
  • Provisionable Stratum levels: 3, 3 with 3E holdover, 4, and SONET
  • LET or RST operation (primary shelf)
  • Up to Stratum 3/3E free-run accuracy
  • Jitter and wander reduction of external timing source
  • A second ETI can be installed for standby operation
  • Telcordia compliant design cabinet is expandable from four shelves to eight
  • Fiber splice and distribution options
  • -48 VDC powered cooling fans
  • Separate vented battery compartment and battery back-up options
  • Standard surge protection
  • Copper line protection in separate compartment (non-cross-connect configurations)
  • Hex key lock (padlockable for additional security)
  • Synchronizes to an external composite clock timing source
Email Us
To place an order or reach customer service, email directly at
Call Us
Call us for immediate customer service and assistance.
Corporate Headquarters