Featured Post
Just 1-2-3 steps to install our Tellabs ONT140W makes it as easy to learn as your ABCs
Featured Post
Top 5 blogs help accelerate awareness and engagements by a factor of 5!

FlexSym Singlemode Fiber to Multimode Fiber Modal Adapting Jumper

Optical LAN
  • Supports any length of SMF from the Tellabs OLT through the splitter up to the limit of the 28dB optical budget
  • Allows re-use of multimode fiber cabling from the splitter location to where the ONTs are mounted (all Tellabs ONT models are supported)
  • Economical one-to-one MMF cabling solution without stranding ports on passive optical splitters
  • Eliminates the cost of installing new singlemode fiber in the horizontal pathways and the final access drops
  • Two versions available for SMF SC/APC connector on OLT/splitter side and MMF ST/UPC connector on ONT side in 3-meters length, plus SMF SC/APC connector on OLT/splitter side and MMF LC/UPC connector on ONT side in 3-meters length.
  • Allows full rate PON service over multimode fiber cabling up to 550 meters
  • Qualified for OM1, OM2, and OM3 multimode fiber cable types
  • Completely passive operation, no power or maintenance required

FlexSym XGS-PON Combiner

Optical LAN
  • Optimized interworking with Tellabs Optical LAN equipment inside buildings and across a campus
  • Tellabs FlexSym XGS-PON Combiner mounts in standard LGX enclosure
  • Combines G-PON and 10G XGS-PON wavelengths onto a single fiber enabling G-PON and 10G across same optical infrastructure
  • Provides optimal upstream filtering to eliminate any unwanted wavelengths maximizing efficiency
  • Connected ONTs can be either G-PON, or 10G XGS-PON, and either closet-based, or deep fiber placement
  • Economical overlay of existing 3rd-party G-PON installs with Tellabs FlexSym Series 10G XGS-PON solution
Email Us
To place an order or reach customer service, email directly at
Technical Support
Call Us
Call us for immediate customer service and assistance.
Corporate Headquarters
Technical Assistance Center (TAC)